LeMond RevMaster Pro - Manual (Page 4)

1. Lift handle up (90°) to
fully release clamping force
Adjusting handle clamping force
(From the factory the clamp should be set around 30-38 lbs to open and close)
fully release clamping force.
2. Using a 3mm hex
wrench, loosen the M6x15
dome screw to free the post
handle pin. Loosen the
screw about 2-3 full turns,
do not remove completely.
Push on dome screw to
disengage teeth on opposite
side.
3. Using a 6mm hex wrench, 3. Using a 6mm hex wrench,
turn the head of the post
handle pin. Turn the
indicator point on the head of
the pin towards the plus sign
to add clamp force, or
towards the minus sign to
remove clamp force. There
are each tooth represents a
change in clamp force.
NOTE: Do not rotate head
while teeth are still engaged.
Document # 300142
Revision 01
07/22/2008
Page 4