Bang & Olufsen BeoVision 11 with Beo4 User Guide (No tuner) - Manual (Page 12)

12
Set up additional equipment
If you connect additional video
equipment to your television,
you can register the equipment
via the SOURCE LIST menu.
When the television is switched
on and you connect additional
equipment to the HDMI IN
socket, the television will detect
an unconfigured source. A
message appears on the screen
and you can follow on-screen
instructions to configure the
source.
Sources have default settings, for
example, sound and picture that suit
most situations but you can change
these settings if you wish. Select the
source and select the ADVANCED
SETTINGS menu.
If your Beo6 remote control has been
configured to the sources set up in
the television and you change the
source button in the television, the
source button for the specific source
in the Beo6 display will no longer
work. Contact your Bang & Olufsen
retailer to have your Beo6 remote
control reconfigured.
Registering the equipment connected to
the television enables you to operate it
with your Beo4/Beo6 remote control.
Highlight a source and press the red button
to set it up. Then you will be asked to name
the source and dedicate a button to the
source. You can now operate the source.
When new equipment is detected, a menu is
displayed with the following options: DO
NOTHING, SHOW SOURCE and CONFIGURE
THE SOURCE CONNECTED TO THIS INPUT. If
you want to set up the equipment, use the
navigation button up or down to highlight
the last option and press the centre button
to bring up a setup menu.
Download a PUC table
During the configuration procedure, you are
asked if you want to be able to control the
connected equipment with your Beo4/Beo6
remote control. Follow on-screen
instructions to download a Peripheral Unit
Controller (PUC) table if available.*
1 The
television must be connected to the Internet.
If your connected equipment is not on the
download list, there is currently no control
solution for it and you must select
UNSUPPORTED SOURCE. You will not be
able to operate your equipment with your
Beo4/Beo6 remote control. Contact a
Bang & Olufsen retailer for more
information.
You can search with latin characters and
numbers. For equipment names with non-
latin characters you can search for a part of
the name that includes latin characters. You
can also use the browse functions to locate
the correct PUC table.
1 *If you use a Beo4 remote control, you may
have to switch on your IR-controlled PUC
equip ment using SHIFT + 9. SHIFT can be
found in the Beo4 LIST.
What is connected?
Continues …
MENU
SOURCE LIST
…