Bang & Olufsen BeoVision 7-40/55 Getting Started - Manual (Page 24)

Set up your television
Follow the guidelines for placement and connection described on this and the
following pages. Several stands and wall brackets are available from your retailer.
Important
Place the TV
When you place the TV, remember that the
built-in motor unit will turn and tilt the TV to a
preset position when you switch it on.
Ventilation
To ensure proper ventilation, allow enough space
above and below the screen. Do not cover the fans.
Motorised stand or wall bracket
Due to the heavy weight of the TV, any moving or
lifting of the TV should be performed by qualified
personnel – using the proper equipment.
At overheating (flashing standby indicator and an
on-screen warning), switch the TV to standby, not
off, in order for the TV to cool down. You cannot
operate the TV during this time.
When you mount the TV on a floor stand or wall bracket, you can tilt and turn the TV on some of the
stands. Only some stands can be tilted and turned with the remote control, other stands can only be
tilted manually.
If the front screen glass should crack or chip, or if it should be damaged in any way, it must be replaced
immediately, as it could otherwise cause injury. You can order replacement front screen glass from your
Bang & Olufsen retailer.
If you have a motorised stand or a wall bracket,
leave enough space around the television to allow
it to turn and tilt freely. Set the maximum angle the TV will turn. See the
Guide for further information.
Tilt/turn
Front glass
24