LinPlug Organ 3 - Manual (Page 35)

reso: reso(nance) is used to set the amount of emphasis around the
cutoff frequency. Higher settings create a more pronounced peak in the
signal while lower settings produce a flatter response.
divider: the divider control sets a sample-rate divider that divides the
current sample-rate by the current control setting.
divider mode: the divider mode pop up menu determines how the
output sample value is created from the input samples. Three options
are available: “AVG”, “STP” and “SLD”. The “AVG” (“Average”) option
calculates the average of the input samples and uses this as the output
sample value for each of the input samples. The “STP” (“Step”) option
takes the first sample in each group of input samples and uses this as
the output sample value for each of the input samples. The “SLD”
(“Slide”) option takes the first sample in each group of input samples,
interpolates between them and uses the interpolated value as the output
sample value for each of the input samples.
mode: changes the signal flow of the Crusher:
1 = bit-reduction -> filter -> divider
2 = bit-reduction -> divider -> filter
wet: the wet dial allows you to set the balance between the processed
"wet" signal and the original unprocessed "dry" signal.
LinPlug Organ 3 User Guide Page 35