Linx Technologies MDEV-GPS-SG - Manual

INTRODUCTION
This software is designed to interface with a SG or SR Series Master Development System and to display the
location and navigation data provided by the module. Documentation for the module can be found by clicking
the “Software Help” label at the top of the main window.
THE PROGRAM INTERFACE
When the program starts, the screen will be empty of data, as shown in the figure below.
The SG or SR Series Master Development system should be plugged into a USB port. When the button labeled
“GPS Paused” is clicked, the software establishes a connection to the board through the USB module and
initiates communication. Please note that the jumper on the development board must connect the TX USB and
RX Module lines on the board’s header. The label on the button changes from “GPS Paused” to “Reading GPS”
once a connection is made. To close the connection, simply click the button again.
WIRELESS MADE SIMPLE ®
SG/SR Series Master Development System
Software User’s Guide
Figure 1: The Initial Screen