Magnum Energy Charge Controller Bracket (MP-CCB) - Manual

MP-CCB Instruction Sheet
Part Number: 64-0044 Rev D 1
Figure 1, MP-CCB Physical Dimensions
Magnum Energy, Inc.
2211 West Casino Rd.
Everett, WA 98204
www.magnumenergy.com
Installation
Before proceeding, use Table 1 to determine for your particular charge controller:
• which side of the enclosure (left or right) to mount the charge controller,
• which enclosure mounting holes (upper or lower) to use to attach the bracket,
• which bracket hole(s) (A-I) to use to mount the charge controller (see Figure 2).
Charge
Controller
Holes to use: (Bracket) / [Enclosure]
Left Side Install Right Side Install
PT-100 (ME) (I) / [upper] (H) / [upper]
Classic w/o Turbo (MN) (B) / [upper] (F) / [upper]
Classic w/Turbo (MN) (A) / [upper] (F) / [upper]
FlexMax 80 (OB) 1 NA (G) and (E) / [upper]
Tristar (MS) (D) / [lower] (C) / [lower]
(ME) = Magnum Energy, (MN) = MidNite, (OB) = OutBack, (MS) = MorningStar
Note 1 - The FlexMax 80 is taller than most controllers and may not fi t if something
is mounted above it. If an MPX extension is to be installed on an MP enclosure, mount
the MPX on the left side to allow the FlexMax 80 to be mounted on the right-hand side.
Table 1, Mounting Holes Used for Charge Controllers
Introduction
The MP Charge Controller Bracket (MP-CCB) enables you to mount charge
controllers to a Magnum enclosure. It can be easily attached to either the
left or right side of the Magnum MMP (Mini Magnum Panel) or MP (Magnum
Panel) enclosure. This bracket is designed to work with Magnum Energy’s PT-
100 charge controller and other common charge controllers on the market.
The MP-CCB comes with the necessary hardware to secure this bracket to an
enclosure and to attach a controller to the bracket (see Figure 1).
Sizes shown in
inches (mm)
Two thread forming #8-32 x 1/2” Torx drive
(T20) screws to mount a charge controller.
Most controllers only use one screw.
Two #8-32 x 3/8” fl at
head Torx drive (T15)
screws to attach the
bracket to the
MMP/MP enclosure.
Holes (x10) for mounting
a charge controller. Before
attaching the bracket, use
the form threading screws
provided to pre-thread the
hole(s) you will use.