Electrolux ER 2866 BN - Manual (Page 14)

13
Installation
Unpacking
Remove all transit packaging, including the door transit
retainers located under the plinth. (Fig 1) and shelf
retainers (Fig 2).
Positioning
The appliance should be located in a well-ventilated,
dry room. To ensure correct operation the appliance
should:
• Not be exposed to direct sunlight.
• Not be installed next to radiators, cookers or other
sources of heat.
• Only be installed in a location where the ambient
temperature corresponds to the climate classifica-
tion for which the appliance is designed.
The climate classification can be found on the rating
plate, which is located on the bottom, left hand side of
the fridge compartment. The table shows the correct
operating ambient temperature for each climate class.
(Fig 3)
Climate Classification Ambient Operating Temp.
SN +10 to +32°C
N +16 to +32°C
ST +18 to +38°C
T +18 to +43°C
If the temperature rises above or falls below the stated
ambient temperature for the climate class, the opera-
tion of the appliance may be affected.
Ventilation
You should also ensure that air can circulate freely
around the back and the top of the cabinet.
Do not block the ventilation grille of the appliance (see
fig. 4)
Levelling
Level the appliance by turning the 2 adjustable feet at
the front of the appliance. The appliance must be level
to prevent vibration and excessive noise and to ensure
the doors shut correctly. (Fig 5)
Fig. 4
Fig. 5
Fig. 3
Fig. 2
Fig. 1
rating
plate