Operation, Technical specifications, Min max – Electrolux ER 3625 B User Manual

Page 12

Advertising
background image

5

OPERATION

Before using

Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water).

Do not use soap or detergent as the smell may
linger. Dry thoroughly.

Setting the temperature

The temperature within the appliance is controlled by
the thermostat situated at the top of the appliance.

To operate the appliance proceed as follows:

Turn the thermostat control beyond the «

» position.

Position min = minimum coldness

Position max = maximum coldness

Turn the thermostat dial to the required position.

The intermediate position is usually the most
suitable.

The thermostat control regulates the temperature
both within the fridge and the freezer compartment.
The thermostat setting can vary as the temperature
inside the appliance depends on the following
factors:

To Start the Appliance

Allow the appliance to stand for 2 hours after
installation.

Plug in the appliance and switch on at the mains
supply. Turn the thermostat control to a midway
setting. The pilot light will light up. Adjust the slider
control, situated on the back wall of the fridge
section, to a midway position between “MIN” and
“MAX”. Leave the appliance for approximately 4
hours for the correct temperature to be reached
before placing food inside.

To switch off the appliance turn the thermostat
control to position “«

»”

– room

temperature

– how often the door is opened

– how much food is stored

– position of the appliance

Control Panel

min

MAX

A

B

ON

A-

Thermostat control

B-

Operation light

Use of an air circulation slider
control - COOL FLOW CONTROL

Your appliance has an air circulation slider control
situated at the rear of the fridge compartment, which
controls the amount of cold air circulated through the
fridge compartment.

When the ambient temperature is between 10°C and
16°C, the slider control should be in the “MIN”
position.

When the ambient temperature is above 16°C the
slider control should be midway between “MIN” and
“MAX”.

When the ambient temperature is very high (i.e. hot
summer days) position the slider control to “MAX”.

D757/1

MIN

MAX

COOL FLOW CONTROL

MIN

MAX

COOL FLOW CONTROL

12

TECHNICAL SPECIFICATIONS

DIMENSIONS

Height

170 cm

Width

55 cm

Depth

60 cm

POWER SUPPLY VOLTAGE AND FREQUENCY

220-240 V / 50 Hz

TOTAL POWER ABSORBED

150 W

AVERAGE DAILY UNITS ELECTRICITY *

1.23 kWh

GROSS CAPACITY

Fridge 135

l

Freezer

121 l

NET CAPACITY

Fridge 134

l

Freezer

90 l

*

This figure is based on standard test results in accordance with European Standard EN 153.

Actual consumption will depend on how the appliance is used and where it is located.

Advertising