Epson ACULASER C3800 - Manual (Page 14)

Safety Instructions 14
EPSON AcuLaser C3800 User's Guide
❏ Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE,
or the surrounding areas. If the printer has been in use, the fuser and the surrounding
areas may be very hot. If you must touch one of these areas, wait 30 minutes to allow
the heat to subside before doing so.
1. CAUTION HIGH TEMPERATURE
2. Do not insert your hand deep into the fuser unit.
❏ Do not insert your hand deep into the fuser unit as some components are sharp and
may cause injury.
❏ Avoid touching the components inside the printer unless instructed to do so in this
guide.
❏ Never force the printer’s components into place. Although the printer is designed to be
sturdy, rough handling can damage it.
❏ When handling an imaging cartridge, always place it on a clean, smooth surface.
❏ Do not attempt to modify an imaging cartridge or take it apart. It cannot be refilled.
❏ Do not touch the toner. Keep the toner away from your eyes.
❏ Do not dispose of used imaging cartridge or transfer unit in fire, as they can explode
and cause injury. Dispose of them according to local regulations.
❏ If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to
clean it up. Because the fine particles can cause a fire or explosion if they come into
contact with a spark, do not use a vacuum cleaner.
❏ Wait at least one hour before using an imaging cartridge after moving it from a cool to
a warm environment to prevent damage from condensation.
1
2