Parkside PNTS 1400 B1 - Manual (Page 9)

9
GB
Vacuuming.fine.dust:
While vacuuming fine dust, you
may find dirt accumulating faster
than usual. For this reason, we
recommend the use of a paper fil-
ter bag for fine dust.
1. Fit the pleated filter (25).
2. Fold the side flaps on the paper filter
bag (26) down on the perforation.
3. Completely unfold the paper filter bag
(26) and pull it over the internal suc-
tion nozzle (8) in the stainless steel
container (9). The connector on the
suction nozzle must be completely en-
closed by the sealing ring on the filter
bag opening.
Wet vacuuming
For wet vacuuming or to vacuum water, fit
the foam filter (23) to the filter basket on
the motor head (3).
When the container is full, the suc-
tion opening is shut off by a float,
and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and emp-
ty the container (see “Cleaning/
Maintenance/Storage”).
If foam or liquid exits, switch off the
machine immediately.
Blow Function
Operation without the use of a filter
is recommended.
• Connect the suction hose (21) to the
connecting blower (17) on the motor
head (3).
Cleaning/Maintenance/
Storage
Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
Cleaning.the.Equipment:
Never.hose.the.appliance.down.
with.water..Never.use.aggressive.
cleaning.agents.or.solvents..This.
could.damage.the.appliance..
• After use, empty the stainless steel
container ( 9):
- Opening the drain plug to allow the
vacuumed liquid to drain out (
10). A liquid residue remains in the
container.
To remove all residual liquids, fold
down the bow handle (1) and take
off the motor head ( 3): fix the
bow handle with the locking le-
vers (16), hold the stainless steel
container (9) with one hand on the
bow handle and the other on the
bottom of the container and pour
out the residual liquid.
• Clean the waste tank with a damp
cloth.
• Wash the foam filter ( 23) with
lukewarm water and soap, and allow
to dry.
• Beat the dust out of the fluted filter
( 25) and clean it with a paint brush
or hand brush.
• Replace the paper filter bag ( 26)
when full (see “replacement parts” for
reordering)