Parkside PLP 100 A1 - Manual (Page 12)

13 GB/IE
Switching off:
j Release the ON / OFF switch 4 .
j Pause: At least 48 seconds
CAUTION! Never heat up the device if it is not fitted with a sol-
dering tip.
j ATTENTION! Never use in continuous operation mode. The flow
of electrical current controls the delivery of soldering heat. As soon
as the ON / OFF switch
4 is released, the delivery of soldering
heat drops. If the ON / OFF switch 4 is pressed again, the deliv-
ery of soldering heat rises. Pay particular attention to achieving an
even delivery of soldering heat to ensure the highest soldering quali-
ty. You can do this by not allowing the soldering tip
1 to become
excessively hot.
Note: The device has a soldering light
3 to illuminate the work-
ing area.
Q
Replacing a soldering tip
CAUTION! DANgER OF BURNS! Allow the device to
cool down before replacing a soldering tip.
j Release the two union nuts 2 using the open spanner 9 .
j Pull the soldering tip 1 or 7 out of the holder.
j Insert another tip into the holder.
j Tighten the two union nuts 2 using the open spanner 9 .
Use
61101_par_Loetpistole_PLP100A1_content LB6.indd 13 30.12.10 13:51