Parkside PABSS 3,6 Li - Manual (Page 12)

6. Technical data
Motor power supply: 3.6 V DC
Idling speed: 200 rpm
Clockwise/Counter-clockwise: Yes
Charge voltage for rechargeable
battery: 6,8 V DC
Charge current for rechargeable
battery: 550 mA
Battery charger supply voltage: 230V ~ 50 Hz
Charging time: 3 hours
Battery type: Li-Ion/1.5 Ah
Weight: 0.4 kg
LED Class 1
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Sound pressure level L
pA
62 dB(A)
Uncertainty K
pA
3 dB
Sound power level L
WA
73 dB(A)
Uncertainty K
WA
3 dB
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Screws without hammer action
Vibration emission value a
h
≤ 2.5 m/s 2
Tolerance K = 1.5 m/s 2
ƽ
Caution:
The vibration value changes according to the
area of application of the electric tool and may
exceed the specified value in exceptional
circumstances.
Keep the noise emissions and vibrations to
a minimum.
Only use appliances which are in perfect
working order.
Service and clean the appliance regularly.
Adapt your working style to suit the
appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in
use.
Wear protective gloves.
7. Before starting the equipment
ƽ
Caution:
Be sure to read the following information before
you use your cordless screwdriver for the first
time:
1. Only charge the battery pack using the
charger (11) supplied.
2. Only use screwdriver bits which are in
perfect working order and appropriate.
3. When screwing into walls or partitions, test
these for electrical, gas or water
connections.
8. Operation
8.1 Charging the battery pack (Fig. 1)
The battery pack is protected from exhaustive
discharge. An integrated protective circuit
automatically switches off the equipment when
the battery pack is flat. In this case the bit chuck
(1) will cease to turn.
ƽ
Caution:
Do not press the ON/OFF switch (9) any more,
if the protective circuit has actuated. This may
damage the battery pack.
1. Check that your mains voltage is the same
as that marked on the rating plate of the
battery charger. Plug the battery charger
(11) in the plug socket and connect the
charging cable (12) to the charging
connection (8). The charging process starts
GB/IE/
CY
12
Anleitung_4513426:_ 22.12.2009 14:09 Uhr Seite 12