Parkside PNTS 1300 A1 - Manual (Page 27)

27
GB MT
You will find illustrations for the
machine on the fold-out pages.
Overview
Housing
1 Motor housing
2 Carrying handle
3 On / off switch
4 4 attachment ports for accesso-
ries
5 Suction connection
6 Waste container
7 4 feet with castors and acces-
sory fittings
8 Cable holder
9 Mains cable
10 Locking clips
11 Blower connection
Accessories
12 3-part vacuum tube
13 Vacuum hose with
14 Handle component
Filter
15 Foam filter for wet vacuuming
16 Material filter for dry vacuuming
17 Paper filter bag for vacuuming fine
dust
. Nozzles
18 Floor nozzle with
19 Turnable insert attachment
with brush and rubber lip, for
vacuuming carpets and smooth
surfaces
20 Crevice nozzle
Contents
Unpack the appliance and check that it is
complete:
The appliance is supplied with the motor
head fitted (see No. 1). To remove the
motor head, open the securing clips (see
No. 10).
1 Motor housing
2 Carrying handle
6 Waste container
7 4 feet with castors and acces-
sory fittings
12 3-part vacuum tube
13 Vacuum hose
15 Foam filter for wet vacuuming
16 Material filter for dry vacuuming
17 Paper filter bag for vacuuming fine
dust
18 Floor nozzle
20 Crevice nozzle
6 cross-head screws
Dispose of the packaging material properly.
Assembly
Pull out the mains plug.
This will prevent danger of injury
from electric shock.
1. Attach the carrying handle (2)
firmly using the cross-head
screws supplied.
2. Attach the feet (7) and secure the
feet with the Philips head screws
supplied.
3. Insert the filter:
- Foam filter for wet vacuuming
(see No. 15).
- Foam filter plus material filter
(see No. 16) for dry vacuum-
ing
- Paper filter bag for fine dust
(see No. 17)
Never.vacuum.without.a.filter!
4. Place the motor housing (1) on
top of the dirt collector (6) and
close it with the clip (10).
5. Connect the vacuum hose (13)
(Bayonet closure) and the acces-
sories.