Parkside PKO 270 B2 - Manual (Page 49)

GB/
MT
health.
■ The work area must exceed 30 m 3 and
sufficient ventilation must be ensured during
spraying and drying. Do not spray against
the wind. Always adhere to the regulations
of the local police authority when spraying
combustible or hazardous materials.
■ Do not process media such as white spirit,
butyl alcohol and methylene chloride with
the PVC pressure hose. These media will
destroy the pressure hose.
2.4 Operating pressure vessels
■ You must keep your pressure vessel in good
working order, operate the vessel correctly,
monitor the vessel, carry out necessary
maintenance and repair work immediately
and meet the relevant safety precautions.
■ The supervisory authority may enforce
essential control measures in individual
cases.
■ A pressure vessel is not allowed to be used
if it has faults or deficiencies that can
endanger workers or third parties.
■ Check the pressure vessel for signs of rust
and damage each time before using. Do not
use the compressor with a damaged or rusty
pressure vessel. If you discover any
damage, then please contact the customer
service workshop.
Do not lose this safety information.
3. Layout
1. Transport handle
2. Pressure switch
3. Pressure gauge (for reading the vessel
pressure)
4. Pressure regulator
5. Quick-lock coupling (regulated compressed
air)
6. Pressure gauge (for reading the preset
vessel pressure)
7. Pressure vessel
8. Supporting foot
9. Drain plug for condensation water
10. Axle screw
11. Wheel
12. Oil drain plug
13. Compressor pump
14. Compressed air hose
15. Air filter
16. Oil sealing plug
17. ON/OFF switch
18. Oil level window
19. Safety valve
20. Quick-lock coupling (unregulated
compressed air)
21. Oil filler opening
22. Washer
23. Spring washer
24. Nut
4. Intended use
The compressor is designed to generate
compressed air for compressed-air driven tools
which can be driven with an air volume of up to
approx. 270 l/min (e.g. a tire inflator, blow-out
pistol and paint spray gun). Due to the limited
air output it is not possible to use the
compressor to drive tools with very high air
consumption (for example orbital sanders, rod
grinders and hammer screwdrivers). For tools
with high air consumption (e.g. orbital sanders,
rod grinders, hammer screwdrivers), check
whether the compressor’s air output is sufficient
to operate the tool in question. The volume of
air supplied by the compressor must be greater
than the volume of air consumed by the
compressed air tool at its operating pressure.
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
49
Anleitung_LB5_4010404:_ 24.02.2011 11:09 Uhr Seite 49