Operation, Switching on / off, Setting the stroke rate – Parkside PGG 15 A1 User Manual
Page 46
46 GB
manufacturer parts only. This will ensure that your device
remains safe to use.
Operation
Never use the device for a purpose for which it was not intended or
with non-original parts / accessories. The use of tools or accessories
other than those recommended in the operating instructions could lead
to you suffering an injury.
Switching on / off
Insert the mains plug into a mains socket.
Switching on:
Press the ON / OFF switch
1
.
Switching off:
Release the ON / OFF switch
1
.
Setting the stroke rate
The stroke switch
2
is used to set the penetration depth of the engrav-
ing. A low setting is normally adequate for most engraving tasks.
Turn the switch for the number of strokes
2
in the
+ direction to
increase the penetration depth.
Turn the switch for the number of strokes
2
in the
– direction to
decrease the penetration depth.
Operation
General safety advice for electrical power tools / Operation