Parkside PDT 40 B2 - Manual (Page 9)

9 GB
Safety of the fastener driving tool / Preparing the product for use / Operation
When loosening the hose coupling, hold the
hose firmly in your hand to prevent injuries
caused by a rebounding hose.
Be absolutely certain to use a ¼‘„ threaded
nipple and a quick-release coupling for the
compressed air connection.
Never place your hands near the mouth when
the device is ready to operate. Otherwise inju-
ries may result.
Pay attention to damage. Check the de-
vice for damage before bringing it into use. If
the device exhibits defects, it must not be oper-
ated under any circumstances.
Do not use any pointed objects. Never
insert pointed and / or metal objects into the
inside of the device.
Original accessories / tools
Use only the accessories and attachments
detailed in the operating instructions.
The use of fasteners or other accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.
Preparing the product for use
NOTE: always wear the protective goggles sup-
plied before putting the tool into operation. Remove
the protective film from the protective goggles before
using for the first time.
Connecting the compressed
air source
NOTE: The compressed air tacker must only be
operated with cleaned, oil-misted compressed air
and must not exceed the maximum operating pres-
sure of 8 bar. The compressor must be fitted with a
pressure reducer in order to regulate the operating
pressure.
Connect the device to a suitable compressed
air source.
1. To do so, press the compressed air hose quick-
release coupling (not included in the scope of
delivery) on the ¼“ threaded nipple
4 of the
compressed air tacker.
Locking is automatic.
2. Connect the other end of the compressed air
hose to the (filter) pressure reducer on the com-
pressor.
Loading the magazine
1. Press the magazine lever 12 and pull the mag-
azine cover back to its stop position.
2. Insert the corresponding fastener (nails, see
Fig. 01 or staples, see Fig. 02) into the maga-
zine
5 .
02
5
01
5
3. Slide the magazine cover forwards until it locks.
Operation
Load the magazine 5 of the compressed air
tacker as described in the chapter “Loading the
magazine“.
Use the pressure reducer to set the correct
operating pressure.
Ensure that the permissible operating pressure
of 8 bar at the device is never exceeded.
Operating pressure that is too high does not
Safety of the fastener driving tool