Parkside PLBS 30 A1 - Manual (Page 65)

65 GB/MT
Q
Original accessories / attachments
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.
Q
Before first use
Q
Fitting the helical spring
Insert the narrower end of the helical spring 3 into the opening
of the multifunctional holder 7 . Ensure that the outwardly bent
end of the helix points upwards and insert it into the recess provid-
ed for it in the multifunctional holder
7 (see arrow in Fig. B).
Push the helical spring 3 into the opening as far as it will go.
Turn the helical spring 3 clockwise to fix the multifunctional
holder 7 in place.
Q
Inserting / replacing soldering tips
CAUTION! DANGER OF BURNS! Allow the soldering
pencil to heat up without a soldering tip.
Removal of a soldering tip 2 or a copper attachment 9 10 11
may only be done when the appliance has been switched off and
the soldering tip or attachment has cooled down.
All soldering tips and attachments have a screw thread and can,
therefore, be easily and quickly replaced on the soldering pencil
1 .
Turn the soldering tip or attachment anti-clockwise to remove it.
Turn the soldering tip or attachment clockwise to fix it in place.
Safety advice / Before first use Safety advice