Operation before first use, Before first use, Fitting the helical spring – Parkside PLBS 30 A1 User Manual
Page 60: Inserting / replacing soldering tips
60 GB/MT
Q
Before first use
Q
Fitting the helical spring
Insert the narrower end of the helical spring
3
into the opening
of the multifunctional holder
7
.
Ensure that the outwardly bent end of the helix points upwards
and insert it into the recess provided for it in the multifunctional
holder
7
(see arrow in Fig. B).
Push the helical spring
3
into the opening as far as it will go.
Turn the helical spring
3
clockwise to fix the multifunctional
holder
7
in place.
Q
Inserting / replacing soldering tips
CAUTION! DANGER OF BURNS! Allow the soldering pencil to
heat up without a soldering tip.
Removal of a soldering tip
2
or a copper attachment
9
10
11
may only be done when the appliance has been switched off and
the soldering tip or attachment has cooled down.
All soldering tips and attachments have a screw thread and can,
therefore, be easily and quickly replaced on the soldering pencil
1
.
Turn the soldering tip or attachment anti-clockwise to remove it.
Turn the soldering tip or attachment clockwise to fix it in place.
Operation
Before first use