Parkside PFMR 1400 B1 - Manual (Page 33)

33 GB
Safety notes for paint and mortar mixer / Before use / Operation General safety advice for electrical … / Safety notes for paint and mortar mixer
tool striking hidden electical lines or
its own power line. Contact with a live wire
could cause metal parts of the device to become
live and lead to electric shock.
Do not use device in surroundings with explosive
atmospheres. Do not mix solvents or substances
containing solvents with a flashpoint below 21 °C.
Do not place cables around any part of your
body.
Only turn the device on or off when it is in the
mixing vessel. Make sure that it is securely and
safely positioned. When mixing, do not place
hands or objects in the mixing vessel.
If the sound pressure level at the work station
exceeds 85 dB(A), wear hearing protection!
Wearing work gloves and safety glasses is rec-
ommended when working with the agitator.
Wearing snug fitting clothing is required.
Before use
Always pull the mains plug before executing
settings on the device.
Mounting the agitator (see Ill. A)
Firmly screw the shaft 6 b to the mixing spiral 6 a .
Subsequently, screw the agitator 6 into the
agitator shaft with the M-14 inner threading 3 .
Secure the chuck with an open-end spanner 2
and tighten the stirrer 6 with a second open-
end spanner 2 .
Dismantling the agitator
To remove the agitator, repeat the process in
the reverse order.
Installing the support bracket
Install the support bracket 7 by securing the
four included crosshead screws in the designat-
ed location on the handle (see Fig. C).
Using the support bracket
Use the support bracket 7 to hang the device
or to set it on the ground. This will prevent it
from dirtying.
Operation
Turning the device ON / OFF
(see Ill. B)
Switching on:
Press the ON / OFF switch 5 .
Switching off:
Release the ON / OFF switch 5 .
Switching on permanent operation:
Secure ON / OFF switch 5 with hold-to-run
button 4 .
Switching off permanent operation:
Press ON / OFF switch 5 quickly.
Setting the speed (see Ill. B)
Note: The ON / OFF switch 5 has a variable
speed control.
Press the ON / OFF switch 5 lighlty to reduce
the speed.
Increase the pressure to increase the speed.
Working with the mixer
Submerge the mixer in the mixture at a low
speed.
After the agitator has been submerged com-
pletely, you may increase the speed.
During the mixing process, move the agitator
around the mixing vessel and mix the mixture
until it is completely processed.