Parkside PABS 10.8 C2 - Manual (Page 40)

40 GB
Attention - Service lines!
Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
Original ancillaries /
accessories
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an in-
creased risk of personal injury for you.
Before first use
Removing / charging / inserting
rechargeable battery pack
Note: The battery is supplied partially charged.
Charge the rechargeable battery in the charging
station for at least one hour before first use. By doing
this the battery will operate at its highest capacity.
You can charge the Li-Ion battery at any time with-
out risk of shortening battery life. Interrupting the
charging process does not damage the battery.
1. In order to remove the rechargeable battery pack
7 , press the release buttons 8 and take the
rechargeable battery pack 7 out of the device.
2. Insert the rechargeable battery pack 7 into the
quick-charger 14 .
3. Insert the mains plug into the mains socket.
The indicator LED 12 illuminates red.
4. The green charge indicator LED 13 shows you
that the charging process is complete and the
battery pack
7 is ready for use.
5. Insert the rechargeable battery pack 7 into
the device.
Checking the battery status
To check the battery status, press the button for
the rechargeable battery LED 2 (refer to main
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED
3 as follows:
RED / ORANGE / GREEN = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery
Changing tools
Your cordless drill / screwdriver has a fully automat-
ic spindle lock
.
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
11 can
be opened simply by turning it .
After you have inserted the required bit and fixed it
in place by turning the chuck
, you can immedi-
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
5 ).
2 Gear Drive
Note: Move the gear selector switch 1 only after
the device has come to a standstill.
In the first gear (Gear selector switch 1
in Position: 1)
you achieve a speed of up to approx. 400 rpm and a
high torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch 1
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.
Torque control / drill step
You can use the torque control / drill step 10 to
adjust the torque. When the value of the torque
General safety advice for electrical power tools / Before first use Before first use / Preparing the tool for use