Parkside PDFP 500 B2 - Manual (Page 26)

26 GB
Disposal / Translation of the original declaration of conformity / Manufacturer Maintenance and Cleaning / Service / Warranty
some materials of the paint spray gun. This can
lead to dangerous reactions.
ATTENTION! Never immerse the paint spray
gun completely in solvent.
After each use, spray thinner (only in the open
air – danger of explosion!) or water
through the device.
To clean the casing, nozzle head 9 and the
spray holes inside it, use a cloth or the cleaning
brush provided. Never use petrol, solvents or
cleaning agents that attack plastic.
First unscrew the stroke stop screw 4 by turning
it anti-clockwise .
Remove the spring 11 .
Remove the needle 10 with the aid of pliers
(see Fig. A).
Clean the needle 10 carefully with the brush 12 ,
also refer to Fig. B.
Replace the needle 10 in the paint spray gun.
Position the spring 11 on the end of the needle 10 .
Tighten the stroke stop screw 4 by turning it
clockwise .
Unscrew the flow cup 3 from the gun by tur-
ning anticlockwise .
Remove the filter 13 , as shown in Figure C, and
clean it with the cleaning brush.
Clean the interior screw thread 14 of the flow
cup 3 with the cleaning brush (see Fig. D).
Replace the filter in the gun (see Fig. C) and tigh-
ten the flow cup
3 by turning it clockwise .
For rust protection you can spray sewing ma-
chine oil through the device after cleaning.
Lubricate all moving parts from time to time.
After cleaning the needle, the thread and seal
must be lightly treated with grease.
Do not use any lubricants containing silicone.
Only store compressed air tools in dry areas.
Service
Compressed air-oper-
ated equipment should only be repaired
by qualified specialists and with original
spare parts. This will ensure that devices
remain safe.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
The warranty is void in the case of abusive and im-
proper handling, use of force and internal tampering
not carried out by our authorized service branch. Your
statutory rights are not restricted in any way by this
warranty.
The warranty period will not be extended by repairs
made unter warranty. This applies also to replaced
and repaired parts. Any damage and defects extant
on purchase must be reported immediately after
unpacking the appliance, at the latest, two days after
the purchase date. Repairs made after the expiration
of the warranty period are subject to payment.
GB
Service Great Britain
Tel.:
0871 5000 720
(0.10 GBP/Min.)
e-mail: [email protected]
IAN 96898