Parkside PSSA 18 A1 - Manual (Page 9)

9
GB IE
-ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check for
misalignment or binding of mov-
ing parts, breakage of parts and
any other condition that may af-
fect the power tool’s operation. If
damaged, have the power tool repaired
before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, tak-
ing into account the working
conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) CAREFUL HANDLING AND USE
OF BATTERY DEVICES
• Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk of fire if a
charger that is suitable for a specific type
of battery is used with other batteries.
• In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of fire.
• Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may cause burns or fire.
• If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes, seek
medical assistance. Leaking battery flu-
id may cause skin irritations or burns.
6) SERVICE
• Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Special Safety Directions for
the device
1) SPECIAL SAFETY INSTRUCTIONS
FOR RECIPROCATING SAWS
• Hold the electric tool by the in-
sulated gripping surfaces when
performing work in which the
cutting tool may come into con-
tact with hidden wiring. Contact
with a live wire can also cause a
charge in metal parts of the device and
result in an electric shock.
• Keep hands away from the saw-
ing area. Do not reach under-
neath the work piece. Upon contact
with the blade there is a risk of injury.
• Only when the electric tool is
turned on should the sawing
blade be moved against the