Parkside PSS 65 A1 - Manual (Page 10)

10
GB IE
Mount the sharpener
1. Select one of the three sharpen-
ers.
2. In order to remove a sharpener
from the working position, you
must press down the release le-
ver for the sharpener (13).
3. Remove the sharpener from the
guide rails, upwards.
4. In the storage positions, the
sharpeners are not fixed to the
right and left side and can be
easily removed from the guide
rails.
5. In order to fasten the selected
sharpener in the working posi-
tion, from above push this into
the guide rails. Press the sharp-
ener down until it snaps into
place.
The sharpeners also present
a safety device. Never use
this device without a sharp-
ener. Risk of injury!
Operation
Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Never operate the device without
the visual protection disk.
- Switch on the equipment only when
it is safely installed on the work sur-
face.
Despite spark protection, al-
ways wear safety goggles
while working in order to
avoid eye injuries.
Keep your hands away from
the grinding disc and grind-
ing belt when the device is in
operation. Injury hazard!.
Switching on and off
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the mains.
1. To switch on, press the “I” On switch
and the device starts up (see 3).
2. To switch off, press the “0” off switch
and the device switches off (see 3).
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.