Parkside PABS 10.8 C2 - Manual (Page 41)

41 GB
In the first gear (Gear selector switch 1
in Position: 1)
you achieve a speed of up to approx. 400 rpm and a
high torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch 1
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.
Torque control / drill step
You can use the torque control / drill step 10 to
adjust the torque. When the value of the torque
setting is reached, the clutch disengages the drive
connection to the chuck.
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling work, select the drill setting by putting
the torque control / drill setting into the position.
For drilling tasks, also push the gear selector
switch 1 to the front (Position: 2).
Preparing the tool for use
Changing the direction of
rotation / unlocking the device
Unlock the device and change the direction of rota-
tion by pressing the rotational direction switch
4
to the right or to the left.
Switching ON / OFF
Switching on:
To start the appliance squeeze on the ON /
OFF switch 5 and then keep it pressed down.
The light 9 comes on with a slightly or fully
pressed ON / OFF switch 5 and illuminates
the working area in poor lighting conditions.
Switching off:
To stop the appliance, release the ON / OFF
switch 5 .
Changing the rotational speed:
The ON / OFF switch
5 has a variable speed
control. Light pressure on the ON / OFF switch 5
causes the device to operate at a low speed. In-
creasing the pressure increases the speed.
Activating the lock
Press the rotational direction switch 4 into the
middle position. The ON / OFF switch 5 is
now blocked.
Tips and Tricks
When screwing into wood, metal and
other materials:
Screw bits are designated with their dimensions
and their shape. If you are unsure, always try
the particular screw bit out to see whether it sits
in the screw head without any free play.
Before you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
Torque:
Smaller screws and bits in particular can be
easily damaged if you adjust the appliance
with too high a torque and/or rotation speed.
Hard screw bed:
Particularly high torques can occur, for example
with metal screws tightened by socket tool bits.
Select a lower rotation speed.
Soft screw bed:
You should also select a low speed in order not
to damage the wood workpiece surface through
contact with the metal screw head. Use a coun-
tersinker.
Before first use / Preparing the tool for use