Curtis BT1056 - Manual (Page 4)

4
Volume up
While in conversation, press the VOLUME + button to increase the volume.
Volume down
While in conversation, press the VOLUME - button to decrease the volume.
■ Switch the call between phone and headset
During a conversation, press and hold the Answer/end button for 3 Seconds, the BT1056 will be switched off
and the call will be transferred to your mobile phone. If you want to transfer the call back to your BT1056,
press and hold the Answer/end for 3 seconds till you hear a beep. Release the button and the call is
transferred back to your BT1056.
■ Using the BT1056 with 2 mobile phones
BT1056 is capable of having two mobile phones connected to the headset at the same time. This will give
you the freedom of having only headset to operate both your mobile phones.
1. Pair the second mobile phone.
Long press the – (volume down) button, release the buttons when the Status Indicator begins to flash red
then blue. It means the headset enter the pairing mode. Your phone then asks if you want to pair with it.
Accept by pressing ‘Yes’ on the phone and confirm with the passkey or PIN = 0000 (4 zeros).Your phone will
confirm when pairing is complete.
2. Active the Multipoint Function
You need to active the multipoint Function by long pressing the headset + (volume up) and - (volume down)
buttons. When you see the blue light turn on for about 3 seconds, then turn off, it means the Multipoint
Function is active.
After pairing the second mobile phone, the first mobile phone will be disconnected with BT1056, so you need
to connect the first mobile phone from the phone setting, and then both Mobiles are connecting with the
BT1056.
Only it must observed that last number redial will dial the number from the last outgoing call, in dependent of
the mobile phones, and the Voice Dialing function only will work on the last paired mobile phone.