Electro-Voice R200 - Manual (Page 6)

R200 OWNERS MANUAL
page 6
COMPATIBILITY
The receiver and transmitter must be on the same
UHF frequency to operate together. Because of
the specialized equipment required to adjust
these units properly, users cannot change the fre-
quencies or make any internal adjustments.
If two or more R200 and/or other VHF/UHF wire-
less systems are being used in the same location,
proper frequency coordination is necessary to
avoid interference. Frequency mixing and spacing
must be factored along with local TV stations to
determine if conflicts will result from a specific
group. Contact your dealer or Electro-Voice for
frequency-selection assistance if you are planning
to add more wireless systems to be operated si-
multaneously in the same location.
POTENTIAL SOURCES OF INTERFERENCE
There are many potential sources of interference
for your wireless system. Any electronic compo-
nent that contains digital circuitry including digital
signal processors (reverb/multi-effects units),
electronic keyboards, digital lighting controllers,
CD players and computers all emit rf energy that
can affect the performance of your wireless sys-
tem. It is always best to place your receiver as far
away from these devices as possible to minimize
this potential source of problems.
BATTERY RECOMMENDATIONS
Fresh 9-volt alkaline batteries from a quality
manufacturer will yield the best performance from
R200 transmitters. 8.4-volt ni-cad batteries can be
used but will yield much shorter operational time.
When the transmitter switch is turned on, the bat-
tery light will flash one time if the battery is good.
If the light does not flash or stays lit continuously,
the battery is weak or dead. If the light comes on
during use, the battery is weakening and should
be replaced as soon as possible.