Curtis FR442 - Manual (Page 12)

11
Door Reversal (on some models)
4 Cubic Foot Models
1. Remove the two screws at the back of the top cover.
2. Remove the top cover by lifting the hack up about 2
〃
and then sliding it forward.
3. Remove the small plug button on the left side of the door top cap.
4. Remove the three screws on the upper binge (right side). Remove the binge.
5. Remove the three screws at the left hinge location on the top plate.
6. Remove the screw in the middle of the top plate and remove the top plate.
7. Lift the door up and off the bottom hinge (right side).
8. Tilt the refrigerator cabinet hack to remove the right leveling leg.
9. Remove the screws on the bottom hinge (right side) and the left leveling leg. Move the
bottom binge to the left side and secure it with the screws and leveling leg.
IMPORTANT: The left leg has a spacer that must be moved to the right side leveling leg when
the door swing is reversed.
10. Screw the right leveling leg, with the spacer in place, back in place on the right side.
11. Position the door on the left bottom binge. With the magnetic gasket holding the door
in place, secure the top hinge with screws.
12. Make sure the door is aligned with the refrigerator cabinet before continuing.
13. Replace the top plate and screws.
14. Slide the top cover back in place and
replace the two screws.
15. Put the plug button in the hole on the
right side of the door top cap.