Curtis SB323 - Manual (Page 7)

Battery installation
Before installation
Remove and discard the insulation tab as figure above:
Replace battery for the remote control
When replacing the battery in the remote control, refer to the
diagram below:
1. Press the catch across. While holding the catch, open the battery
door.
2. Fit the battery observing polarity as shown. When replacing the
battery, use only the same CR2025 type specified.
Battery care
Dispose of used batteries with regard to the recycling regulations in
your area.
Weak batteries can leak and damage the remote control.
Do NOT short circuit batteries or throw them into water, the general
rubbish or in a fire.
Replace them in good time!
Power control
Aux In source
To turn the speaker on
Connect the supplied AC/DC adapter and the indicator will turn red.
Press Standby button to place the unit to working status. The
indicator will turn to corresponding color.
FUNCTION LED
AUX 1 green
orange
BLUETOOTH blue
Power On red
NOTE: Before using different external connection functions, please
complete external connection with other devices , then power on the
unit!
To turn the speaker off
Press Standby button on the remote control or hold Standby button
on the side of the unit.
NOTE:If the unit is not used for a long period of time, disconnect the
power adapter.
may include:
TV/DVD/VCR
AUX connection
1. Connect the AV cable to audio output jack (white jack=L, red
jack=R) on DVD Player and to the audio input jack inlet on the rear
of the unit.
2. Press Source button repeatedly until the indicator turns Green.
GB-12 GB-13
AUX 2
1 1
Aux In source