Epson Stylus NX515 - Manual

*411638300*
*411638300*
If anything is missing, contact Epson as described on the back.
Note: The model name of your product may vary slightly from the one shown above.
The included CD and documentation apply to all products in the series.
Caution: Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
Canada only: For French speakers, remove sticker(s) from the backing sheet and
place over corresponding text on the control panel.
Remove all protective materials.
Unpack
1
Start Here
Select language
3
Press or to select your language, then press OK.
3 Squeeze the edge guide and slide it left.
Tip: If the feeder guard is in the way, flip it forward.
4 Load paper against the right edge and behind the tab, with the printable
side face up.
Note: Don’t load the paper sideways; always load it short edge first.
5 Slide the edge guide over.
Continue with section 6 to choose your connection type and install software.
5 Press each cartridge down until it clicks.
6 Close the ink cartridge cover. Press it down until it clicks.
7 Lower the scanner.
8 Press the OK button to charge the ink. Charging takes about 3 minutes.
Note: Your NX510 Series ships with full cartridges and part of the ink from the
first cartridges is used for priming the NX510 Series.
Caution: Don’t turn off the NX510 Series while the ink system is charging or
you’ll waste ink.
(Included for
Canada only)
1 Connect the power cable.
 Caution: Do not connect to your computer yet.
2 Raise the display screen, then press the On button.
Turn on and adjust
2
Power cord
Series
Install ink cartridges
4
Note: Do not load paper yet.
1 Lift up the scanner, then open the cartridge cover.
2 Shake the ink cartridges gently 4 or 5 times, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may leak.
4 Insert the cartridges in the holder for each color.
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extensions, and raise the stopper.
Note: If you are using legal-size paper, do not raise the stopper.
5
Load paper