Curtis SDVD9002 - Manual (Page 5)

7 6
Connecting to the monitor
The unit can also be connected to the external LCD monitor.
Connect the unit to power by AC/DC adapter or cigarette lighter adapter.
Then connect the unit DC OUT jack to DC IN 9-12V Jack of the LCD Monitor by a DC/AV
cable. Also use this DC/AV cable to connect the AV OUT jack of the unit to AV IN
jack of the Monitor.
Please refer to the illustration below.
Note: You're advised to supply both units the power by the cigarette lighter adapter
only. The AC/DC adapter is used to supply power of one unit only and as the charger
to charge the main unit if it's with built-in battery.
In Car Installation
1. Fit the headrest mount to the DVD Player / Monitor as required.
NOTE: Both the headrest mounts are the same, there is no difference for
DVD Player or Monitor.
The DVD player will fit to the mount
in this position, as shown below.
Slide the vertical straps A and B through the
strap lock upon the back of the DVD player,
or monitor, as shown.
Fold and secure the horizontal straps on to
the back of the mount until the velcro attaches.
Ensure the DVD player or monitor is mounted
centrally.
Turn the headrest and player around so the backs are facing you.
Turn the headrest and player around so the front is facing you.
ON OFF
B RIGHTNESS
AV OUT DC OUT
OK
A B
C1
C2
D1
D2
E1 F1
F2 E2
A B
C1
C2
D1
D2
OK
Bring straps C1, C2, D1 &D2 in front of the DVD Player and attach
to the velcro as shown.