Auriol 2-LD3051-6 - Manual

      
WRISTWATCH
Intended use
This electronic appliance is intended for time display. Any
other use or modification of the electronic appliance does
not comply with the intended uses. The manufacturer is
not liable for damages caused by improper use or
misuse. The device is not intended for commercial use.
Cleaning instructions
Clean the product with a dry, lint-free cloth. A glasses
cleaning cloth is ideal.
Time setting: Watch without date display
Carefully pull the crown out all the way. By turning the
crown you may set the time. To finish the setting press
the crown back in all the way.
Time setting: Watch with date display
To set the time, carefully pull the crown out all the way.
By turning the crown you may set the time. Carefully
press the crown back in halfway to the case. The date
can be set by turning the crown. To finish the setting
press the crown back in all the way.
Replacement of battery (SR626SW)
Battery replacements must be performed by an expert to
avoid damaging the case or gaskets.
Warranty
We provide a 3-year warranty for this item. The warranty
period starts from the date of sale (receipt, proof of
purchase). Within this period we rectify all faults which
are attributable to material and manufacturing defects at
no cost. For damage which is attributable to improper
treatment, e.g. dropping, knocking, or water damage,
there is no warranty claim.
Water resistance
Water resistant up to 5 bar. The bar value specifies the
atmospheric overpressure which is applied during testing
(DIN 8310).
Strap Shortening Instructions
Your watch strap may be shortened in two ways.
1. At the buckle
Unlock the safety cover (if applicable) and open the
buckle. The strap is held in position by a spring bar. The
spring bar can be compressed with a pointed tool to
enable shortening of the strap. Move the strap to the
desired position and allow the spring bar to lock into
place.
2. At the strap
Shortening of the strap can also be achieved by
removing segments. Open the buckle and remove the
spring bar as described in part 1.
Place the watch on a soft surface with the dial facing
downward. The segments that can be removed are
marked with an arrow. Push a pointed tool into the
opening on the backside of the strap and push the bolt
out of the strap in the direction of the arrow. Pull out the
bolt (you may need to use tweezers).
The strap can now be disassembled.
Remove as many segments as necessary in the
described fashion and reassemble the strap by pushing
the bolt inwards in the opposite direction of the arrow.
Reassemble the buckle with the spring bar.
Disposal of the electronic appliance
This electronic appliance may not be disposed of
with normal household waste. Dispose of the unit
at an approved disposal facility or at your local
recycling centre. Please observe the current rules
and regulations when disposing of the appliance.
Contact the disposal system if in doubt.
Disposal of the batteries
Please dispose of your batteries properly in
containers especially set up at retailers. Batteries
do not belong in household waste. Dispose of the
batteries at an approved disposal facility or at your
local recycling centre. Contact the disposal system
if in doubt.