Extron electronic HDMI 201 Rx - Manual (Page 11)

HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-6 HDMI 201 Tx/Rx • Installation and Operation 2-7
1 . Loosely attach the mounting brackets to the transmitter
or receiver using the four machine screws and washers
supplied with the mounting kit.
2 . Hold the transmitter or receiver against the inside of the
surface through which it will be mounted. Mark the four
screw holes and the table material to be removed on the
inside of the surface to which you are mounting the device.
3 . Remove the table material. Test the fit by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse file to enlarge the hole.
4 . Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
5 . Using the provided four wood screws, secure the brackets
to the mounting surface.
6 . Slide the transmitter or receiver up and down in the
mounting brackets until the face of the transmitter or
receiver is at the desired height. Tighten the screws that
secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a
. Mark the location of the brackets relative to the screws.
b . Remove the transmitter or receiver from inside the
furniture.
c . Tighten the screws.
d . Replace the unit inside the surface (step 5).
Projector mounting
The receiver can be mounted on a projector bracket using either
of the following optional Extron projector mounting kits:
• PMK 300 multi-product pole mount kit (part #70-374-01)
• PMK 350 low profile, multi-product pole mount kit
(part #70-563-02 [black] or part #70-563-03 [white])
PMK 300 mounting
Mount the receiver to a PMK 300 bracket as follows:
1
. If necessary, remove the feet from the bottom of the
receiver.
2 . Mount the receiver to one of the bracket’s three mounting
plates using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down (figure 2-5).
Extron
PMK 300
Multi-product Pole Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
DVI 201 or HDMI 201
Receiver
Power Supply
Bracket
Brace
Figure 2-5 — PMK 300 projector mounting a receiver
N On the side mounting plates, the device is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
3 . If the power supply is connected to the receiver , use the
two included tie wraps to strap the power supply to one of
the brackets.