Ernesto Z30264 - Manual (Page 16)

16 GB/MT
Safety Instructions
for Batteries
J Remove the batteries from the device if they are
not going to be used for a prolonged period.
J CAUTION! DANGER OF EX-
PLOSION! The batteries must never
be recharged!
J When inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
J If necessary, clean the batteries and device
contacts before inserting the batteries.
J Remove spent batteries immediately from the
device. There is an increased danger of leaks!
J Batteries must not be disposed of in the normal
domestic waste!
J Every consumer is legally obliged to dispose of
batteries in the proper manner!
J Keep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
J If the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
J Avoid contact with the skin, eyes and mucous
membranes. Any parts of the body coming into
contact with battery acid should be rinsed off
with copious amounts of water and / or a doc-
tor contacted if necessary!
Q
Use
Q
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the lower section with container
6 firmly
and turn the upper section 1 in an anticlock-
wise direction (see Figure A) until the arrow on
the top 1 is aligned with the arrow on the
base with container 6 .
2. Now please pull the top 1 off the base with
container 6 .
3. Pull the motor 3 carefully off the base with
container 6 .
4. Pull the battery ring 7 off the motor 3 .
5. Insert 4 new batteries type AA 1.5 V (R6).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
6. Place the battery ring 7 back on to the motor
3 .
7. Fill up the base with container 6 with pepper-
corns or coarse salt. The best result will be
achieved when filling the base with container
6 up to 75 %.
8. Put the motor 3 back on the base with con-
tainer 6 .
Indication: Please make sure that the con-
tacts
4 , 5 face each other (see fig. A).
9. Put the top 1 back on the base with container
6 .
10. Hold the base with container 6 firmly and
turn the top 1 in a clockwise direction (see
fig. B) until the arrow on the upper section 1
is aligned with the arrow on the base with con-
tainer
6 .
Q
Using of the salt
and pepper mill
j Pull off the aroma seal cover 11 from the bot-
tom of the base with container 6 before use
(see fig. B).
j Please keep the button 2 pushed to activate
the salt and pepper mill. The bulb 9 on the
base of the salt and pepper mill will then be
simultaneously activated.
Q
Adjusting the grinding level
j Turn the adjustable screw 8 clockwise to re-
ceive a finer grinding level (see fig. C).
j Turn the adjustable screw 8 anticlockwise to
Safety Information / Use