Excalibur electronic H691 - Manual (Page 5)

8 9
Charging your
Forever Flashlight
10-in-1 Lantern
Your Forever Flashlight
10-in-1 Lantern includes
three great options to
charge your unit. For direc-
tions on these options see
below:
Charging your unit
using your built-in
rechargeable batteries.
It is charged by winding
the handle on the unit. For
best results, follow these
steps in charging:
1. Turn the unit off.
2. Turn your
P OWER
SWITCH
knob to
ON
.
3. Pull out the
CRANK
HANDLE
, located on the side
of the unit.
4. Hold the unit parallel
to the ground and wind the
handle three to five minutes
(Figure 1). Rotate the han-
dle at a speed of approxi-
mately 120 rounds per
minute. It is recommended
to charge your Forever
Flashlight 10-in-1 Lantern
for three to five minutes
before first use or after long
periods of non-use.
NOTES:
• While winding the han-
dle of the Forever
Flashlight 10-in-1 Lantern,
a green indicator light will
be on. This will signify that
the charging is in the
process. If both indicator
How to Use
lights are on (red and
green) this indicates that
you are using the crank han-
dle at a high enough speed
to charge. This will indicate
the voltage is increasing
steadily.
• Your Forever Flashlight
10-in-1 Lantern will pro-
vide you with up to thirty
minutes of radio (volume at
1/3 the capacity) when
charged by winding the
CRANK HANDLE
for two to
three minutes. The
BLINKER
and
SIREN
will work for
approximately ten minutes.
If the Forever Flashlight
10-in-1 Lantern is not going
to be used for two months
or more–remove both the
3 C batteries and the re-
chargeable battery.
If the unit is completely
drained of energy, it is rec-
ommended to use the
AC/DC adaptor. Plug the
unit into an electrical outlet
to fully charge the internal
Figure 1: The Forever Flashlight
10-in-1 Lantern is charged
by winding the handle
on the unit.