Ericsson T28s - Manual (Page 97)

N
o
t
fo
r
C
o
m
m
e
rc
ia
l
U
s
e
E
ri
c
s
s
o
n
M
o
b
il
e
C
o
m
m
u
n
ic
a
ti
o
n
s
A
B
96 Accessories
end of the line. Use this alternative only if Full Handsfree does not work
properly.
Full Handsfree
Full Handsfree means that the phone handles the call in full duplex mode.
This considerably increases the quality of speech, since you do not have to
wait until it is your turn to speak.
For Full Handsfree to work properly, your phone adapts to the sound
environment around the handsfree equipment. This adaptation might take a
few calls. During this learning phase, the person you are talking to might hear
an echo of his or her own voice (because the sound goes from the speaker into
the microphone again). However, this disappears as the other person speaks. If
the echo lasts longer than the first few calls, try Basic Handsfree instead.
Tip! Set the handsfree type to ‘Full Handsfree’ first. If speech quality is poor,
set the ‘Basic Handsfree’ type instead.
To set the handsfree type
1. Scroll to Settings , Y E S , Handsfree , Y E S , Handsfree Type , Y E S .
2. Select the type you want.
When using a Portable or Vehicle Handsfree unit, you may choose to answer
incoming calls with Any Key or Auto.
• Any Key: If you use the phone with handsfree equipment and this function
is turned on, you can answer an incoming call by pressing any key, except
the N O key.
• Auto: If you choose the automatic answering mode, an incoming call is
answered automatically after one ring signal, if the phone is used with
handsfree equipment.
To set an answering mode
1. Scroll to Settings , Y E S , Handsfree , Y E S , Answering Mode , Y E S .
2. Select a mode.
If you choose the Normal alternative, you have to answer calls as normal.
Tip! You can also answer calls by using the Voice Answering function. See
“Voice Answering” on page 78.
Answering Mode