Elta 2322USB - Manual (Page 19)

19.
GENERAL INSTRUCTIONS
Turning on and off
Turn on/off: To avoid unnecessary power consumption, always set the function selector (8) to position TAPE
(OFF) when not using the unit.
1. Use the function selector (8) to choose an operating mode: TAPE (OFF), CD/USB or TUNER.
2. Adjust the volume using the buttons + VOL UP (2) and - VOL DN. (3).
3. To turn off the unit, set the function selector (8) to position TAPE(OFF).
Electronic volume control
- The unit uses an electronic volume control.
- Press + VOL UP (2) or - VOL DN (3) on the unit to increase or reduce the volume.
- Release the button when you have reached your desired volume level.
Listening to the radio
Recommendations for a better reception:
- UKW (FM): The unit is equipped with a FM wire antenna (23) at the rear, which should be fully uncoiled.
Direct the wire antenna for a better reception.
- MW (AM): The unit has a built-in AM antenna. Change the position of the unit when the reception is poor.
Radio reception
1. Set the function selector (8) to radio mode.
2. Use the band selector (18) to select a frequency range: AM, FM or FM ST.
The display shows the selected frequency range (FM or AM) and the current frequency (XXX.X MHz or
XXX:X KHz).
3. Use the TUNING knob (10) to search a desired station.
4. To turn off the unit, set the function selector (8) to position CD/USB or TAPE (OFF).
NOTES:
• If a single FM (STEREO) station is poor and you hear a lot of background noise, set the band selector to
FM (MONO). This way the reception often becomes better.
• The display shows (((FM ST))) when the band selector is set to FM ST. and a stereo station is played.
CD PLAYBACK
Insert/ take out a CD
Before you open the CD compartment, always make sure the CD is not spinning. Always press (17) on the
unit or STOP/ on the remote control first.
- Insert a CD with the printed side facing up.
- After you have inserted the CD, carefully lower the CD door until it is completely closed.
- The CD is now ready for playback.
- To take out a CD, place one finger on the center of the CD (central shaft). Hold the CD with the other
fingers on its edges and carefully lift it up.
- IMPORTANT: Always hold a CD on its edges. Protect the CD surface from finger prints, stains or dirt.
Use a special CD cleaning cloth or cleaning kit to remove dirt or stains.
Normal CD playback (CD/MP3/USB)
1. Set the function selector (8) to position CD/USB. The POWER LED (4) lights up and the display shows
DISC and no.
2. Press OPEN/CLOSE (11) to open the door of the CD drive on the top of the unit.
3. Insert a CD with the printed side facing up and close the door of the CD drive manually.
4. The display shows three dashes “- - -“ for a few seconds and subsequently the total number of tracks.
5. Press (7) on the unit or PLAY/PAUSE on the remote control to start playback of the first track.