Echo 99944230001 - Manual

installation
1. Loosen two (2) screws (A) and remove center locating screw (B).
Pull gear case assembly from drive shaft housing.
2. Set power head / driveshaft so that power head rests on tank stand.
3. Slide new gear case onto drive shaft housing so that gear case rests
upright on wheel.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
4. Tighten bolts (F), clamping the cutting attachment onto the
housing.
5. Install self-tapping screw into locating hole (E) in gear case.
IMPORTANT
Assure gear case wheel and engine remain properly aligned while
installing self-tapping locating screw.
NOTe
After converting your SRM to a Power Edger, access www.echo-
usa.com or call ECHO at 1-800-673-1558 to get the appropriate
Power Edger operator’s manual.
X7672230500
A
B
A
X767000220
01/10
PE P
ro
t
orquE
G
Ear
C
asE
a
CCEssory
K
it
i
nstallation
i
nstruCtions
P/N 99944230001
bladE rEPlaCEmEnt
Level 1.
Tools Required: T-wrench, Locking Tool, Needle Nose Pliers,
13 mm Open End Wrench
Parts Required: POWER BLENDX TM 8 oz. (P/N 91014) or
Lithium Base Grease, Blade P/N 69601552632,
split pin P/N 90030020022
NOTe
Grease gear case every 15 - 25 hours of use. Replace blade when
it is worn shorter than 6 inches. Remove blade and adapters before
greasing to prevent damage to gear and bearings.
1. Shut engine off. Disconnect spark plug lead from spark plug.
F
E
D
Tools Required: 5/16 in. Wrench