Casio IT-2000D33E - Manual (Page 35)

E-36
Things to Remember When Using the Printer
1. Printing Intensity
1 Printing speed may be slow and a one-dot difference between two lines may occur during
high-duty printing, such as printing charts, etc. This is to prevent excessive current.
2 The LF error may occur if there is more than a one-second interrupt between printing
individual lines. When paper tape is used, set a larger printing area or continuous printing.
3 If battery low (low battery pack voltage) is detected, the print job will be stopped. However,
after you resume printing, a one-dot difference between two lines or reduced character
spacing may occur.
4 After you feed paper by turning the feeding dial, the characters may be printed with
reduced character spacing. You can avoid this by using the program to load paper before
printing.
5 If some problem occurs on the printer, immediately turn the power off, and remove the
cause of the problem before starting to the Data Collector again. If you cannot remove the
cause of the problem, contact a CASIO service provider.
6 Print without printer paper loaded can impair the head or damage drive system
components. Be sure to load printer paper before you start printing.
7 Use only recommended printer paper.
Use of other printer paper can adversely affect printing quality and the service life of the
printer, and can result in loss of performance.
8 Pay attention to the following points when storing printer paper:
• Temperatures above 60
°
C may cause the paper to discolor naturally. Do not store
printer paper in high temperature or humid locations.
• Store printer paper in a cool, dark location. Also, do not leave printer paper in the direct
sunlight for long periods.
• Plastic film containing plasticizer, ester-based rubber erasers, or tape glue or adhesive
can cause fading, and contact with organic solvents and diazzo copy paper, and
fingernail scratches can cause coloration.
2. Other
1 The operating temperature is 5 to 35
°
C is during printing on 2-ply and label paper.
2 Insert new paper when the red end mark starts to appear on the paper you use.
3 Recommended paper: Use only CASIO-specified printer paper.
4 Store the IT-2000D33E/53E with the head-up lever down when it is not to be used for a
long time.
5 Do not turn the feeding dial just after printing is finished. Doing so might damage the
feeding dial.
6 If the printer is used for a long period, paper scraps can accumulate and impair printing
quality. If this happens, the thermal head must be cleaned. Contact a CASIO service
provider.
Warning! Do not touch the thermal head during and just after printing is finished.
Handling the Printer