Casio HS-30W - Manual

Operation Guide HS-30W
1
MA0510-EA
ILLUSTRATION
Year Month
Day
Seconds
Seconds
Minutes
TIME DISPLAY STOPWATCH DISPLAY
Minutes Hour
Hour
Day of
the week
PM
Lap counter
Press .
Split time
Lap time
1/100th of a second
Total
elapsed time
Pressed down for a few
seconds to change between
12/24-hour formats.
• A sticker is affixed to the glass of this stopwatch when you purchase it. Be sure to remove the sticker before using
the stopwatch.
• Depending on the stopwatch model, the configuration of your stopwatch may differ somewhat from that shown in
the illustration.
GENERAL GUIDE
Every time the B button is pressed, the display is switched between TIME and STOPWATCH displays.
STOPWATCH DISPLAY
A button ..... Starts and stops timing.
B button ..... Toggles between the current time and stopwatch screens.
C button ..... Registers a lap/split time.
R button ..... Recalls lap/split time records and total elapsed time.
SPLIT TIME AND LAP TIME
Split time (SPLIT) is the time
elapsed from the start to a
specific point.
Lap time (LAP) is the time
elapsed from one point to another
or for one lap around a track.
START
1ST SPLIT
2ND SPLIT
3RD SPLIT
START
1ST LAP
2ND LAP
3RD LAP
USING THE STOPWATCH
A signal confirms A and C button operations.
Working range
The total elapsed time and split time display is limited to 9 hours 59 minutes 59.99 seconds. Lap time display is
limited to 59 minutes 59.99 seconds.
Thereafter it will be reset and started again. The lap counter starts from 1 to 99 and repeats from 0.
NORMAL TIME
0
a
(a)
START STOP RESET
CHART
BUTTON
OPERATION
DISPLAY
NET TIME
0
a b
(a) (a) (a + b)
START STOP START STOP RESET
CHART
BUTTON
OPERATION
DISPLAY
(Loss time)
After stopping a net time operation by pressing A, you can resume it by pressing A again.
LAP/SPLIT TIMES
A maximum of 9 lap/split time records and total elapsed time are automatically stored into the memory, and
recalled by pressing the R button.
Once 9 lap/split time records are stored (counter shows a flashing value greater than 9), pressing C displays the
current lap/split time, but does not store it in memory.
0
a
(a)
b
(a + b)
c
(a + b + c) (t)
START
1ST LAP 2ND LAP 3RD LAP
1ST SPLIT (a)
2ND SPLIT (a+b)
3RD SPLIT (a+b+c)
STOP RESET
CHART
BUTTON
OPERATION
DISPLAY