Casio SE-S10 Quick Start - Manual

Input the desired fl at tax rate to the appropriate department key.
A) Turn the key to the “PGM” position.
B) Press the ~ key.
C) Enter tax rate.
(Example: For 6% enter “6”, 5.75% enter “5.75”.)
D) Press the appropriate department key.
E) Repeat step C) and D) to set other department key.
F) Press the s key to end tax programming.
Note: In case of setting the wrong tax rate to the key, please enter ? and press those depart-
ment keys above, and quit this procedure by pressing k key, and start from the begin-
ning of this procedure.
Quick Start Guide
Casio Model Numbers SE-S10
Press / for more information
3
6
Choosing the language if necessary
Setting Tax Rates
Please keep this sheet for future reference.
REG
OFF
RF
PGM
CAL X
Z
PGM
~
N
N
k
Start tax program
Enter tax rate and press dept key.
Enter tax rate and press dept key.
To end the setting.
Example1: Set state tax 6% to department 2, 3 key
D) Install the supplied 58mm thermal paper roll by lifting up the
platen arm (Push open button) and placing the paper roll into the
printer well. Close the cover fi rmly.
1
Load the Memory Protection Batteries and Paper Roll
A) Remove the printer cover. B) Open battery compart-
ment cover.
C) Insert 2 new “AA” type batteries
in to the compartment.
6 6
To prevent to lose all of your setting and sales data, we
recommended you to install the memory protection bat-
teries.
IMPORTANT Be sure that the plus (+) and minus (-) ends of the batteries
are facing in the directions indicated the illustration inside the
battery compartment.
Initialize Your Cash Register
A) Insert the supplied key and
turn to the “OFF” position.
PGM
B) Plug the power cord into an AC outlet, then a message is printed.
2
REG
OFF
RF
PGM
X CAL
Z
~
B"B
M
k
Start tax program
Enter tax rate and press dept key.
Enter tax rate and press dept key.
To end the setting.
Example 2: Set state tax 5.5% to department 2 key and tax
7% to department 3 key
For Add-ON Tax, please refer to the user’s manual.
5 Printer switch for receipt or journal
A) You can choose the printout language from ten languages.
B) Read the printout and follow the procedure printed on the chit.
Select the language code (0 ~ 9) and press p key.
In case of printng a journal;
A) Turn the key to the “PGM” position.
B) Perform steps below.
Z o Z u
In case of issuing receipts;
A) Turn the key to the “PGM” position.
B) Perform steps below.
Z o ? u
Default printer defi nition is receipt printer.
4 Setting the Date and Time
A) Follow the procedure printed on the chit to set the date and time.
REG
OFF
RF
PGM
CAL X
Z
PGM