Casio SE-S10 Manual - Manual (Page 12)

12
E
Part-1 QUICK START OPERATION
8. Basic Programming for QUICK START Mode Switch
REG
OFF
RF
PGM
CAL X
Z
Procedure Purpose
1. To select the date format and monetary mode (if necessary)
You can select the date format and monetary mode after initialization depending on
the requirements in your area. Default date format is Day/ Month/ Year and default
monetary mode is add 2.
C
?ZXX
X? p
Date Format Selections
A
Year/ Month/ Day ?
Day/ Month/ Year Z
Month/ Day/ Year X
Monetary Mode Selections
B
Add 0 (0.) ?
Add 1 (0.0) Z
Add 2 (0.00) X
Select number from list B
(To end the setting)
P3 appears in mode display
Program set code No.
Select number from list A
Select date format
and
monetary mode
2. Input the desired add-in tax rate to the appropriate department key.
(This procedure below programs add-in tax rate only. If you want to set add-on tax
or tax with special rounding, refer to page 27 of this manual.)
A) Enter 1 and press the key.
B) Press the ~ key.
C) Enter tax rate. (Example: For 6% enter “6”, 5.75% enter “5.75”.)
D) Press the appropriate department key.
E) Repeat step B) and C) to set other department key.
F) Press the key to end tax programming.
Note: In case of setting the wrong tax rate to the key, please enter
?
and press
those department keys above, and quit this procedure by pressing key,
and start from the beginning of this procedure.
Setting the tax rates
Example :
Set add-in tax 8% to department 2, 3, 15% to department 4 key.
~ Start tax program.
8 Enter tax rate and press dept key.
8 Enter tax rate and press dept key.
15 Enter tax rate and press dept key.
To end the setting.