Powerplus POW63753 LAWNMOWER 118CC 400MM EN - Manual (Page 10)

POW637..
EN
Copyright © 2010 VARO P a g e | 10 www.varo.com
Fig 5F

Standing behind the unit, grasp the brake control
handle and hold it against the upper handle as
shown in fig. 5F.

Grasp the brake control handle as shown Fig. 5F
and pull up rapidly. Return it slowly to the rope
guide bolt after engine starts. Release the brake
control handle to stop the engine and blade.
7.3 Operation procedures
During operation, tightly hold the brake handle with both hands.
Note: During operation, when the brake handle is released, the engine will
stop and thus stopping the lawnmower from operating.
7.4 To stop engine
CAUTION: The blade continues to rotate for a few seconds after the engine
is shut off.
1 Release the brake control handle to stop the engine and blade.
2 Disconnect and ground the spark plug wire as instructed in the separate engine manual
to prevent accidental starting while equipment is unattended.
7.5 Connection for auto move
Turn the Self-drive control handle , the lawnmower will move forward utomatically with about 1
m/s.
CAUTION: your mower is designed to cut normal residential grass of a
height no more than 250mm. Do not attempt to mow through unusually tall
dry or wet grass (e.g, pasture) or piles of dry leaves. Debris may build up on
the mower deck or contact the engine exhaust presenting a potential fire
hazard.
7.6 For the best results when mulching
Clear lawn of debris. Be sure that the lawn is clear of stones, sticks, wire or other foreign
objects which could be accidentally thrown out by the mower in any direction and cause
serious personal injury to the operator and others as well as damage to property and
surrounding objects. Do not cut wet grass. For effective mulching do not cut wet grass
because it tends to stick to the underside of the deck preventing proper mulching of the grass
clippings. Cut no more than 1/3 the length of the grass. The recommended cut for mulching is
1/3 the length of the grass. Ground speed will need to be adjusted so the clippings can be
dispersed evenly into the lawn. For especially heavy cutting in thick grass it may be necessary
to use one of the slowest speeds in order to get a clean well mulched cut. When mulching long
grass you may have to cut the lawn in two passes, lowering the blade another 1/3 of the length
for the second cut and perhaps cutting in a different pattern than was used the first time.
Overlapping the cut a little on each pass will also help to clean up any stray clippings left on
YOUR MOWER IS EQUIPPED WITH A CENTRAL HEIGHT ADJUSTMENT
LEVER OFFERING 5 HEIGHT POSITIONS
(for DYM1561,DYM1661,DYM1661E,DYM1562,DYM1662,DYM1662E) And
YOUR MOWER IS EQUIPPED WITH A CENTRAL HEIGHT ADJUSTMENT
LEVER OFFERING 10 HEIGHT POSITIONS
(for DYM1563,DYM1663,DYM1663E,DYM1564,DYM1664,DYM1664E)
Fig 7b
Fig 7c
Stop mower and disconnect spark plug cable before changing mower cutting
height.
The central height adjustment lever offers you 5(10) different height positions.
To change the height of cut, squeeze adjuster lever toward the wheel, moving up or
down to selected height. (Fig.7a,b,c)
All wheels will be in the same height of cut.
6. MAINTENANCE INSTRUCTIONS
SPARK PLUG
Use only original replacement spark plug. For best results, replace the spark plug
every 100 hours of use. (refer to ENGINE OWNER'S MANUAL)