Powerplus POWLI301 RECHARGEABLE HALOG EN FLASHLIGHT 75W EN - Manual (Page 2)

POWLI301 EN
Copyright © 2014 VARO P a g e | 2 www.varo.com
5.1 AC/DC charger

Insert the charger plug into the DC jack of the unit and plug the charger into a mains
supply socket (230V – 50Hz)
 Make sure that the voltage rating of the mains supply corresponds with that of the
charger.
 The time required to fully charge the battery is around 15 hours.
Important note: Only use the charger supplied by the manufacturer.
Other chargers may damage the unit.
5.2 12V DC car plug charger

Plug the car plug adaptor supplied into the cigarette lighter socket of your car and
insert the adaptor plug into the DC jack of the unit.
 The time required to fully charge the battery is around 8-10 hours.
6 OPERATING INSTRUCTIONS
 Charge the battery completely before you use your spotlight for the first time.

To switch ON : press the trigger switch (1).
 To prevent that the spotlight can be switched on accidentally (during storage : fire
may occur !) you can block the trigger by engaging the locking switch (6).
 Trigger switch can be locked in the 'ON" position for continuous operation by sliding
the trigger switch into to the locking position. Slide back to un-lock
 It is not recommended to use the unit continuously. It is designed for intermittent use
only.

Charge the battery immediately after each use.
7 MAINTENANCE
7.1 Battery replacement

Pull off the rubber impact ring guard.
 Pull off the soft grip of the revolver handgrip.
 Open the housing by loosening the 6 screws.
Attention: ON/OFF switch, lock, charging socket are held in place by
the 2 housing parts and may fall out !
 Pull out the battery and its terminals, replace the 6V 4Ah Lead Acid Battery.
 Re-assemble in opposite order. (take care not to place the rubber guard ring upside
down)
7.2 Bulb replacement

Pull off the rubber impact ring guard.

Pull off the soft grip of the revolver handgrip.
 Open the housing by loosening the 6 screws.
 Grasp and lift out the bulb guard mesh.
 Replace the bad bulb with a new (type : H3/ 75W)Quartz Halogen bulb) and re-
assemble in opposite order. (take care not to place the rubber guard ring upside
down)