Emerson Process Management Bristol ControlWave CW_35 - Manual (Page 2)

Product Data Document
420ds9b
July 10, 2007 - Page 2
ControlWave Upgrade Kits
www.EmersonProcess.com/Remote
Remote Automation Solutions
Permit access to onboard FLASH RAM (33XX
has FLASH for boot project only)
Optional one or two 10/100 Mbit Ethernet ports
CW_10 MFIB with four serial ports
CW_30 with two BIP serial ports
CW_35 with two serial ports
CW_31 with one Ethernet port
New Communication card or 3310 MFIB for high
speed ports & IP/PPP serial communication
CPU speed increase of up to 1000%
New Protocols – DNP3.0 & CIP
Software Migration
In order to preserve most of your ACCOL program
development time and expense, the ACCOL Trans-
lator utility will allow application program conversion
to ControlWave Designer IEC 1131 Structured Text.
For most applications, the ACCOL Translator will
reduce the conversion effort by up to 80% vs. rewrit-
ing the program.
To properly take advantage of the ACCOL Transla-
tor, one must know ACCOL, ControlWave Designer,
understand the ACCOL application and have access
to the ACCOL source file. Once the application is
translated, it typically requires some degree of edit-
ing, depending on the complexity of the program,
and thorough testing prior to deployment on-site.
Emerson Process Management can provide you
with training to do the translation or you can rely on
our Application Support Group to do the translation
for you.
Specifications
CW_10, CW_30, and CW_35 CPU
32 bit, 150 MHz ARM processor
Memory battery backup: 7000 hours
Optional one or two independent 10/100 Base-
T ports with RJ-45 connectors (CW_30 and
CW_35 only)
•
•
•
•
•
•
•
•
•
•
•
•
Ethernet port isolation: 500 Vdc
One 3 pin Utility Port for Flash downloading
system flashware
System Watchdog relay on CW_10 MFIB
LED status indicators – 6 failure status LEDs,
Watchdog and Idle and communication LEDs
Memory
Program execution: 4 MB SD RAM
Data Memory : 1 MB SRAM battery backed
memory
File and Historical Archive memory: 16 MB on-
board flash
CW_10 Serial Communication Ports
4 Serial communication ports: Located on the
MFIB: 9 pin ‘D’ connectors with standard 33XX
pin out
Ports A & C: RS232 – 115.2 K baud
Port B: Configurable Modem/RS485 – 115.2
K baud. Supports all existing 3310 private and
switched network modems
Port D: RS485 – 115.2 K baud, multi-drop up to
32 nodes
ESD protection on RS 485 ports - IEC 801
CW_30 and CW_35 Serial Communication Ports
2 Serial communication ports: BIP ports. (On
CW_30 only BIP ports extended from CPU
board and mounted on an external bracket)
BIP ports are configurable RS232/RS485
– 115.2 K baud
BIP ports are 9 pin ‘D’ connectors with standard
33XX pin out
ESD protection on RS 485 ports - IEC 801
CW_30 and CW_35 Serial Communication Card
2 port and 4 port serial communication cards
available
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•