Powerplus POWXQ5102 ANGLE GRINDER 950W 115MM EN - Manual (Page 9)

POWXQ5102
EN
Copyright © 2013 VARO NV P a g e | 9 www.varo.com
8.2 Switching On (Fig 6)
To switch on:
POWXQ5102: press the rear of the on/off switch key down, then slide it forward until it latches.
Allow the disc to reach full speed before you touch the workpiece.
8.3 Switching Off (Fig 7)
To switch off:
POWXQ5102: press the rear of the on/off switch key down, it will jump backward in off
position.
The disc will gradually slow down and eventually stop after a few seconds.
Do not put the machine down when the disc is still turning.
Never unplug a running machine, always switch off first before pulling out the
plug!
When the disc becomes jammed, for any reason, switch off the machine
immediately to prevent damage to the motor.
9 USE
9.1 Working direction (fig 8)
 The machine must always work opposite to the direction of rotation. Therefore, never
move the machine in the other direction! Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
9.2 (Rough) grinding (fig 9)
For the best (rough)grinding results, hold the grinding wheel at an angle of between 30°
。
and
40° to the workpiece surface and guide back and forth over the workpiece in steady
movements.
Never use a cutting disc for grinding/roughing!
9.3 Cutting
When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane.
The cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard stone.
It is prohibited to use the machine on asbestos materials!
Never use a grinding disc for cutting!
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power plug.
10.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.