Powerplus POW204 ANGLE GRINDER 500W 115MM EN - Manual (Page 7)

POW204 EN
Copyright © 2012 VARO P a g e | 7 www.varo.com
Be aware the screws are tightened well enough. Check regularly if the screws
are still fixed.
7.2.2 Disassembly

Remove the flange nut and the grinding disc with lower flange from the spindle.

Unscrew the 4 screws (with washers) en remove the fixing-ring.

Remove the guard from the machine.
7.3 Mounting a grinding disc (Fig.3)
Use grinding discs of the correct dimension. Use fibre reinforced grinding discs only. The
grinding disc must not touch the edge of the guard.
Remove the plug from the mains

Press the spindle lock (5) and turn the spindle (6) until it engages in the lock. Keep the
spindle lock pressed during this procedure.

Remove the flange nut (10) from the spindle using the spanner (11).

Position the grinding disc on the flange (9).

Place the flange nut on the spindle and tighten it using the spanner.

Release the spindle lock and check that the spindle is unlocked by rotating it.
7.4 Mounting grinding discs and roughing discs
Fig. 4 and 5 show how to mount the flange (10) when using thick (4 – 8 mm) and thin (2,5 – 4
mm) discs.
8 OPERATION
8.1 Special attention when starting the machine

Clamp the workpiece and make sure that the workpiece cannot slide from under the
machine during the cutting activities.

When working with the machine, always hold it firmly with both hands and provide for a
secure stance.

Always direct the cable to the rear away from the machine.

Insert the mains plug only when the machine is switched off.

Apply the machine to the workpiece only when switched on
Never use the machine for grinding magnesium workpieces.
8.2 Switching On

Press the end of the ON/OFF switch down then slide it forwards.

The machine will start. Hold the switch.
8.3 Switching Off

Release the ON/OFF switch, the machine will be switched OFF. The disc will gradually
slow down and eventually stop after a few seconds.
Do not put the machine down when the disc is still turning.