Powerplus POW30050 IMPACT DRILL 710W EN - Manual (Page 5)

POW30050 EN
Copyright © 2012 VARO P a g e | 5 www.varo.com
7 OPERATION
7.1 Selecting the operating mode (fig. A)
Select the required operating mode before use (drilling or hammer drilling).
§ For drilling in wood
:
metal, plastics and soft stone and for driving screws, slide the switch
(5) to the left.
§ For drilling in concrete or hard stone, slide the switch (5) to the right.
Always wait until the motor has come to a complete standstill before
changing the operating mode.
7.2 Changing the direction of rotation (fig. A)
§ Press the forward/reverse switch (4) to the left to drill or to fasten screws.
§ Press the forward/reverse switch (4) to the right to loosen screws,
Always wait until the motor has come to a complete standstill before
changing the direction of rotation.
7.3 Adjusting the speed (fig. A)
This machine has been fitted with an adjusting wheel (2) for the maximum speed.
§ Turn the adjusting wheel (2) as indicated on switch (1) to set the maximum speed.
7.4 Switching on and off (fig. A)
§ To switch the machine on, press the on/off switch (1). The further you press the switch,
the higher the speed of the machine.
§ To switch off the machine, release the on/off switch (1).
§ To switch the machine to continuous mode, keep the on/off switch (1) pressed and at the
same time press the lock-on button (3). Subsequently release the on/off switch.
§ To switch off continuous mode, press the on/off switch (1) again.
7.5 Body rotation.
The body of your POW 30050 can be rotated over 180° (90° to left – 90° to the right). To do
so, pull the body rotation lock button (9) backwards to unlock the body, turn the machine to the
desired position, release the button.
The machine can be blocked in -90°, -45°, 0°, 45° & 90°. (the lock button latched into place
automatically)
8 TECHNICAL DATA
Mains voltage 230V
Mains frequency 50Hz
Power input 710 W
No load speed 0-3500 min
-1
N° of strokes no load 0-42.000 min
-1
Chuck capacity 13 mm
Weight 3.3 kg