Powerplus POW5633 POWER STATION 4-IN-4 EN - Manual (Page 4)

POW5633 EN
Copyright © 2014 VARO P a g e | 4 www.varo.com
4.4 Power tool use and care
 Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
 Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
 Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
4.5 Service
 Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
5 SPECIAL SAFETY INSTRUCTIONS
 Lead-acid batteries generate hydrogen gas during normal operation. More gas is
generated when the battery is charging.
 Hydrogen gas is: Explosive, Poisonous to inhale, Highly flammable
 Never allow the red and black clamps to touch each other.
 Never allow the red and black clamps to touch the same metal object.
 Only attempt to jump start a vehicle, boat or motorcycle in a well ventilated area.
 Never connect the red clamp to the positive battery terminal first
 Protect this unit from direct sunlight, direct heat and moisture.
6 FEATURES
 Jump start
 12V power supply with 12V cigarette lighter output
 Emergency light
 Compressor
7 OPERATING INSTRUCTIONS
7.1 Jump start
Under no circumstances allow the red and black clamps to touch each
other or a common conductor.
 Switch off the engine of the vehicle or boat.