Powerplus POWX0076LI CIRCULAR SAW 18V LI-ION 165MM ONE FITS ALL EN - Manual (Page 7)

POWX0076LI EN
Copyright © 2013 VARO P a g e | 7 www.varo.com
 Do not cause short circuits. If connection is made between the positive (+) and negative (-)
terminal directly or via accidental contact with metallic objects, the battery is short circuited
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
 Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
 Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:

Carefully wipe the liquid off using a cloth. Avoid skin contact.

In case of skin or eye contact, follow the instructions below:
 Immediately rinse with water. Neutralize with a mild acid such as lemon juice or
vinegar.

In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
8.2 Chargers
 Use the charger provided with the tool only to charge the battery
 Never attempt to charge non-rechargeable batteries.
 Have defective cords replaced immediately.
 Do not expose to water.
 Do not open the charger.
 Do not probe the charger.
 The charger is intended for indoor use only.
9 ADJUSTMENTS
Always disconnect the battery pack from the cordless circular saw before
making any adjustment or attaching any accessories.
9.1 Replacing the saw blade (Fig. 1)
Only use sharp and undamaged saw blades. Cracked or bent saw blades must be replaced
immediately.
 Place this circular saw on its side on a flat surface. Advice you bring the base plate (10)
down as if a minimum depth cut which is ease to operate.
 Push the spindle lock button toward motor housing as the arrow shows in Fig. 1 and firmly
hold it.
 Turn the blade clamp bolt anti-clockwise by using the Allen key that supplied with the tool.
 Remove the blade clamp bolt and outer flange.
 Raise the lower guard (16) by using the lever for lower guard (17), and then remove the
saw blade.
 Clean the saw blade flanges, then mount the new saw blade onto the output spindle and
against the inner flange.
 Make sure the saw teeth and arrow on the blade is to be the same direction as the arrow
on the lower guard.
 Reinstall the outer flange, and tighten the blade clamp bolt.
 Make sure that the saw blade runs freely by turning the blade by hand.