Powerplus POWX0172LI DRILL/SCREWDRIVER 18V LI-ION EN - Manual (Page 10)

POWX0170LI, 0172LI, 0173LI & 0175LI
EN
Copyright © 2010 VARO P a g e | 10 www.varo.com
6.7 Adjustable torque clutch
This drill is equipped with an adjustable torque clutch for driving different types of screws into
different materials. The proper setting depends on the type of material and the size of screw
you are using.
TO ADJUST TORQUE: Identify the 24 torque indicator settings located on the front of the drill.
Rotate adjusting ring (2) to the desired setting.
1-5
For driving small screws
6-10 For driving screws into soft material
11-15 For driving screws into soft and hard materials
16-20 For driving screws in hard wood
21-22+1
21-23+1(X0170LI)
( ) For heavy drilling
Not for POW X0170LI:
For hammer drilling
* Drilling hard smooth surfaces
When drilling hard smooth surfaces use a center punch to mark desired hole location. This will
prevent the drill bit from slipping off center as the hole is started. However, the low speed
feature allows starting holes without center punching if desired. To accomplish this, simply
operate the drill at a low speed until the hole is started. The material to be drilled should be
secured in a vise or with clamps to keep it from turning as the drill bit rotates. Hold tool firmly
and place the bit at the point to be drilled. Move the drill bit into the work piece applying only
enough pressure to keep the bit cutting. Do not force or apply side pressure to elongate a hole.
WARNING:
Be prepared for binding or bit breakthrough. When these situations occur, drill has a tendency
to grab and kick opposite to the direction of rotation and could cause loss of control when
breaking through material. If not prepared, this loss of control can result in possible serious
injury. hen drilling metals, use a light oil on the drill bit to keep it from overheating. The oil will
prolong the life of the bit and increase the drilling action. If the bit jams in work piece or the drill
stalls, release switch trigger immediately. Remove the bit from the work piece and determine
the reason for jamming.
6.8 LED light.
The white LED light on the front (above the battery pack) will light when you operate the
machine, providing the work area to be lighted.
7 MAINTENANCE
7.1 General
Your tool has been designed to operate over a long period of time with a minimum of
maintenance.
- Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Clean your tool using a damp cloth.
- Your charger does not require any maintenance apart from regular cleaning, unplug it before
cleaning.
Use a soft brush or dry cloth.
- KEEP VENTILATION SLOTS CLEAN! Periodically check the air vents for dust or other
debris. Clean with compressed air (max. 3 bar)
Do not use any abrasive or solvent-based cleaner. Use clean cloths to remove dirt, carbon
dust, etc.